Those are the only toilets I’m familiar with, at least with regards to maintenance and troubleshooting.
I’ve cleared a lot of clogged shitters, not once have I had to ensure the flapper is down in the reservoir. That’s “why won’t it stop running” not “why won’t I the water go down”.
Once the flapper lifts, it won’t close again until the tank empties completely. If the toilet clogs and you try too many times to flush it down instead of breaking out the plunger right away; sometimes the water can’t overflow out of the bowl fast enough to let the tank drain fully, so it just endlessly flows. Doesn’t happen to all toilets, but it’s still good to know when your toilet full of turds just won’t stop dumping water on the floor.
Closing the flapper stops the water in the tank from going into the bowl.
This is completely unnecessary IMO. You stop the water in the tank from going into the bowl by not continuing to flush a clearly clogged toilet. There’s no issue with the flapper in this scenario and it will automatically seal in a few seconds from water pressure.
That’s another option. Sometimes there is no valve immediately beside the toilet, sometimes it’s crusty af and won’t turn or seal. This can be quicker.
Those are the only toilets I’m familiar with, at least with regards to maintenance and troubleshooting.
I’ve cleared a lot of clogged shitters, not once have I had to ensure the flapper is down in the reservoir. That’s “why won’t it stop running” not “why won’t I the water go down”.
Once the flapper lifts, it won’t close again until the tank empties completely. If the toilet clogs and you try too many times to flush it down instead of breaking out the plunger right away; sometimes the water can’t overflow out of the bowl fast enough to let the tank drain fully, so it just endlessly flows. Doesn’t happen to all toilets, but it’s still good to know when your toilet full of turds just won’t stop dumping water on the floor.
Right, I am aware of all this. Just shut the water off and go to the plunger steps.
Turning off the water will stop the tank from refilling. Closing the flapper stops the water in the tank from going into the bowl.
I would imagine most people aren’t fast enough on the draw to think about doing this first step.
This is completely unnecessary IMO. You stop the water in the tank from going into the bowl by not continuing to flush a clearly clogged toilet. There’s no issue with the flapper in this scenario and it will automatically seal in a few seconds from water pressure.
That’s another option. Sometimes there is no valve immediately beside the toilet, sometimes it’s crusty af and won’t turn or seal. This can be quicker.